SAFETY

CHIMNEY CHECK

Have your chimney inspected by a professional chimney sweep or woodstove-fireplace installer; choose a professional who has earned credentials from the National Chimney Sweep Guild, Chimney Safety Institute, or the HEARTH Education Foundation.

Failing to maintain your woodstove or fireplace properly can lead to a chimney fire. Chimney fires occur when combustible deposits on the inner walls of the chimney ignite. These combustible deposits, called "creosote," are a natural byproduct of woodburning. A fire hazard exists if 1/4 inch of creosote (or more) coats the inner walls of the chimney.

Chimney fires do not occur in clean, intact, properly installed chimneys. Have a professional chimney sweep clean and inspect your appliance at least once a year. More frequent cleanings may be required, based on the type of wood burned, the type of appliance, and the frequency of use. In general, an older, uncertified woodstove, or any appliance that is used frequently, will require more than one cleaning per year.

Detection. The first indication of a chimney fire is usually the noise—a roaring sound that grows louder as the fire’s intensity increases. Clouds of black smoke and sparks will be seen exiting the top of the chimney; in severe fires, flames can extend several feet about the chimney. 

In case of a chimney fire, follow these steps:

Call the fire department immediately.

Alert others in the house to evacuate.

Close the appliance’s dampers and/or the primary air inlet controls, limiting the fire’s air supply and reducing its intensity. If there is a barometric damper in the chimney connector, plug or close the opening in the barometric damper.

Open the appliance door just enough to insert the nozzle of a 10 lb. dry chemical fire extinguisher rated for Class ABC fires. Discharge the entire content of the extinguisher into the appliance and shut the door.

If possible, wet down the roof and other outside combustibles to prevent fires ignited by shooting sparks and flames.

Closely monitor all combustible surfaces near the chimney. During severe chimney fires, these surfaces can become hot enough to ignite.

After a chimney fire, have the chimney inspected by a professional chimney sweep or woodstove/fireplace installer; choose a professional who has earned credentials from the National Chimney Sweep Guild, Chimney Safety Institute, or the HEARTH Education Foundation.

DO NOT USE THE CHIMNEY UNTIL IT HAS BEEN INSPECTED BY A PROFESSIONAL. 

The excessive heat produced by a chimney fire can crack chimney walls, damage chimney liners, and damage some types of factory-built chimneys. If not repaired, these damages create a greater possibility for any subsequent chimney fire to spread beyond the confines of the flue to the house.
Information courtesy of the Hearth, Patio & Barbecue Association